3/4-20 HSS Tap And Die Set， UNEF Machine Thread Tap And UNEF Round Thread Die Right Hand

Worked perfectly for my task.

I will probably use this one time. I needed to fix threads for a motorcycle triple tree. It was what I needed and it worked perfectly!

Much better quality than I expected at this price. I used the tap on the drive axle of my Enco RF30. I didn’t have the correct tap drill so I used an undersized pilot. The tap cut without protest.The die was only used for final sizing of single point machined threads but cut easily.Gave four stars as the die didn’t have a case and was shipped loose.

I had a lawnmower spindle and pulley nut stripped on me. I used the 9/16” tap and die set to successfully re-thread the nut and spindle. I filed a couple of threads off of the spindle and was able to start the die, and then used a wrench and large mouth pliers to twist the die to re-thread the spindle bolt. The tap worked a lot easier to re-thread the nut. Better than buying a full set of taps and dies which I probably would have never used.

Great job

Smashed the threads on my 3.55 pinion. This helped both fix the threads and clean them out. Used a bit of oil to make it easier. Cleaned both the pinion and the nut. I would recommend it but you need to buy the die holder too.

Mostly bought for the tap. Did the job and did it well. It doesn't come with a tap wrench, so do plan on that.

I ordered this to retread an air fitting on a Chinese tire inflator I bought that had the wrong threads.This tool worked great. Cut the threads into steel no problems and are still just as sharp as when I got them.