How to use HOTPDR pdr tools? Introduce: 1.Clean the dent with a clean wet cloth; 2.Mount the glue stick into the glue gun,pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes; 3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is); 4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue); 5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter); 6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent; 7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen; 8. Clean the repaired place with a clean wet cloth. Package list : 1 pc 2in1 T bar 24 pcs purple tabs With attractive packaging
A**A
Good slide hammer, cheap pull tabs.
The slide hammer is pretty good quality. The problem I had was the tabs kept breaking. On the second pull, my first tab broke. I thought it was a fluke. I used another tab and again 3 pulls later it snapped. I used a third tab and it also broke. So in trying to pull about a 2"-3" dent I went through 3 of the tabs and they all snapped. So the hammer is good but that tabs didn't last more than a few pulls.
Trustpilot
5 days ago
2 weeks ago
