Crazepony 3pcs FPV Camera Mount Inductrix Tiny Whoop for Quadcopter Camera

It works. It's just a 3d print. Each one fits the cam a little different, so the sizing is *slightly* inconsistent. They did make the right call though, making the mount a little loose, so you don't have to jam it in there. There are 2 things I recommend if you purchase.1. Get some tack and shove it in the bottom so it holds the camera better.2. Use adhesive Velcro squares so you can keep the cam in the mount and move the mount itself.

I still order these for my Eachine TX01 even though I knew they wouldn't fit and they give you three so if you botch up one you still have two left:). I have to look for screws to attach it to my e010 and do just a little modification where the lens goes or use doubt side tape to hold the camera into the holder, but the good old rubber band did the trick without screws for now! I like it :)

These require modification to fit the AKK micro camera/TX combo. Used to make a better mount than just hot gluing the circuit board to the craft/vehicle.

This was the only mount I could find for an all in one camera system. Was a good fit, but a little loose. YouTube tips told m I should heat the mount for a good custom fit. Did the trick, but still felt it best to put a little hot glue in for good measure. Works like a charm now. Happy with my product overall, good job Crazepony!

It does what it suppose to.

They serve their purpose but they are thin prints and fragile at the screw hole. But they come in a three pack so if you break one you have two spares, or you could just hot/super glue it in place if the screw holes break.

I bought it for my new FPV camera since it was suggested as "bought together". It doesn't really fit the cameras (bought two different ones), and no way to secure the camera to the mount. The camera without a shroud will tightly fit into the pocket, but then slip out easily. To even use it with the camera that already had a shroud, I had to cut a corner and then hot glue the camera to it. I would not buy these mounts again. My cameras are GOQOTOMO GT02 and AKK Micro FPV AIO.

I flew mine for long periods of time multiple batteries which warped the mount. But it still functioned well and there are 3 of them so it’s not bad. I talked to the seller and they were very receptive about the issues I had and were very helpful. I will be buying again with my next tiny whoop.