Husky Liners Weatherbeater Floor Mats | Fits 2012-2022 Toyota Sequoia; 2012-2021 Toyota Tundra, CrewMax & Double Cab, 2012-2017 Tundra Regular Cab | Front Row, 2-pc Black - 18561

Bought these to replace Tundra car mats. What a difference! Wish we had done this sooner. They fit perfectly over every inch. Price was right, too. Looking into replacing all the mats front to back in both autos. Buy these.

Easy install on drivers side.Passenger side easy as well after reading review suggesting drilling a small pilot hole in carpet.Colect dirt well, hold melting snow.

Perfect fit. Fits like a glove. On Toyota Sequoia 2 nd gen

Fits well in my 2016 Toyota Tundra Double Cab. 100% worth the investment. Keeps my carpets clean and the dirt and water contained. Easy to install, has held up well, seems very durable. No bad smells and doesn’t slide around. Thick quality.

Bought it for my truck. It fits perfectly without any folded corners. It has a lip on the borders so the dirt/mud stays inside. I just remove it off the truck to wash/clean/dry and install it back!This brand (Husky Liner) is a great alternative to the other name brand which can be quite expensive.

Perfect fit and durable. Covers more area than factory the factory weather mats. The only complaint for which I gave them four stars, is the passenger mat plastic anchoring screw. It is too short to reach thru the weather mat and grip the carpet. However, the mats fit so well I doubt the passenger mat will move much at all.

These are the best floor mats I have had in any of my vehicles. They cover all of the carpet in the front, and they hold any mud or water that gets on them. Easy to clean, and they don’t move around. Worth the buy.

Installed these the other on my recently acquired 2019 Toyota Tundra. I found fit and build quality to be very good. I was concerned about comments I had read about the passenger side front matt sliding around because of the supplied hold down screw not working. The are no directions and when I first tried to get the hold down screw to bite I got no where with it and it just spun and spun. I could not get it to "grab" the carpet fibers. I then took better look at the screw and another look at the carpet. I realized the screw was not designed to grab the carpet fibers, it was designed to pierce the carpet and grab the carpet backing. I put the mat into place and carefully ran an 1/8" drill bit down thru the hole in the mat. (There is plenty of room between the carpet and sheet metal pan due to the sound deadening material but you should still be careful!) Once I made the small hole the screw works great and Keeps the matt secured in place. For those not wanting to pierce their carpet with a small hole placing a couple strips of velco (the hook side) onto the bottom of the matt might work as well. Dinged the ease of installation rating for the lack of install instructions supplied. Otherwise, I think they are great.