Tool Guy Republic10 PC SAE Stud Remover and Installer Kit

I’ve been using jam nuts for stud removal for 15 years. These are a huge time saver.Use the nut with set screw at the top for install, run the stud in and when it’s tight just loosen the set screw with provided Allen wrench.The other set work great even with limited threads available for extraction. Just thread on as much as you can tighten together and extract.Huge time saver, worth every penny!

Nice kit, fast post and they work quite well. Havent put them to full use by trying to remove the most difficult studs but it looks promising.

It works just as advertised. Super convenient for a quick and painless stud removal. Everything should come in a foam case like this.

Really nice set, worked perfect for installing new studs on my engine build! The case it comes in is perfect to just lay in your toolbox, all tools should come in a case like this! Thx

There are zero instructions with this set. That said, if you’re installing or removing studs you probably don’t need them anyway. Two key things to know are the long piece with threads on the outside goes on first, threaded nose facing up. The cap with threads in the inside goes over that. Tighten the two VERY tightly. Now use the hex on the first piece to unscrew that stud from whatever it was in.Metric set works well for Toyota vehicles which use fine threads for nearly everything; it doesn’t come with coarse thread parts, so make sure you know what you need.