Hunter Rain Clik WRCLIK Wireless Rain Sensor System, Automatic Shutoff for Sprinkler Controllers, Mounts Easily to Gutter or Wall, Compatible with Most Irrigation Controllers

Exact replacement for the original. Cheaper to buy the complete sensor than the components separately.

Easy to install - I had it up and running in under 30 minutes. Hunter has installation videos on YouTube that I followed.

Took about a hour to install on my Hunter Pro-C .So far it’s working perfectly. Rained a day after I installed it and sprinklers didn’t come on, even though it was their scheduled day.

Easy install and the rain sensor and receiver come already paired. Note: this is a complete kit that includes the sensor bracket for mounting on gutter. No need to purchase separate bracket.Easy to wire into the controller and mounting was simple. System worked great until we had a heavy Colorado hail storm (in June -- crazy weather!). So much quarter-inch hail it looked like an inch or more of snow on the ground. It beat the plants to H-E-double-toothpicks and, unfortunately, the wireless rain sensor as well. This failure may be a corner case, but Colorado does get a fair amount of hail (just say'in). I'll give it the benefit of the doubt this first time.I'm replacing the kit with same and will give it another try. Didn't seem fair to claim it as a warranty replacement since it was a bad storm. BUT, if it fails again in the near future, I'll look for a different solution with the knowledge this wireless rain sensor isn't robust enough for this climate.

Replaced the old one that was 15 years old. Fired right up and is working perfectly. Only four wires to connect. (5th was not used by my rainbird)

This rain sensor has a sealed battery that goes out every 5-7 years. Swapped out the old sensor and transmitter in 20 minutes. Saved a lot of money doing it myself! Anyone can do it.

The battery on my previous rain sensor was on the fritz for a year or two and this year it completely died. Although I could not replace just the sensor alone, the change from the old model to this newer model was very easy. So far it has been working very reliably - I wouldn't hesitate to do this replacement myself again.

This was very easy to install as an accessory to my Hunter controller. The instructions were very good. Installation time should be between 30min - 1 hour. Now I don't have to be concerned about the sprinkler running while it's raining.